To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Master Cylinder Bench Bleeding

    Warning: Refer to Brake Fluid Irritant Warning in the Preface section.

    Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution in the Preface section.


    2027955
  1. Secure the mounting flange of the brake master cylinder in a bench vice so that the rear of the primary piston is accessible.
  2. Remove the master cylinder reservoir cap and diaphragm.
  3. Install suitable fittings to the master cylinder ports that match the type of flare seat required and also provide for hose attachment.
  4. Install transparent hoses to the fittings installed to the master cylinder ports, then route the hoses into the master cylinder reservoir (1).
  5. Fill the master cylinder reservoir to at least the half-way point with brake fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers for the recommended brake fluid.
  6. Ensure that the ends of the transparent hoses running into the master cylinder reservoir are fully submerged in the brake fluid.
  7. Using a smooth, round-ended tool, depress and release the primary piston as far as it will travel, a depth of about 25 mm (1 in), several times. Observe the flow of fluid coming from the ports.
  8. As air is bled from the primary and secondary pistons, the effort required to depress the primary piston will increase and the amount of travel will decrease.

  9. Continue to depress and release the primary piston until fluid flows freely from the ports with no evidence of air bubbles.
  10. Remove the transparent hoses from the master cylinder reservoir (1).
  11. Install the master cylinder reservoir cap and diaphragm.
  12. Remove the fittings with the transparent hoses from the master cylinder ports. Wrap the master cylinder with a clean workshop cloth to prevent brake fluid spills.
  13. Remove the master cylinder from the vice.
   


© Copyright Chevrolet. All rights reserved