1

Windshield Wiper Arm Finish Cap

Procedure

Use a small flat-bladed tool to remove finish cap.

2

Windscreen Wiper Arm Nut

Caution: Refer to Fastener Caution in the Preface section.

Procedure

1. Locate the transparent circle with a black dot in the centre at the lower windscreen blackout area.
2. Position the wiper arm to the pivot shaft so that the wiper blade is centred across the transparent circle.
3. Lift the arm blade portion while pushing down the arm onto the pivot shaft.
4. Install the wiper arm nut.
5. Hold the wiper arm stationary in position as previously stated.
6. Torque the wiper arm nut.
7. Release the wiper arm assembly.
8. Repeat the same procedure for the other wiper arm.

Tighten
24.5 N·m (18 lb ft)

3

Windscreen Wiper Arm Assembly

Procedure

Grasp the end of the wiper arm at the wiper transmission pivot shaft and rock the arm side to side in order to release the windscreen wiper arm from the wiper transmission pivot shaft.