Orlando

Camshaft Seal Replacement — 1.6L LDE, LXV, 1.8L 2H0, LUW and LFH

Special Tools

For equivalent regional tools, refer to Special Tools .

1. Remove the camshaft position actuator adjuster. Refer to Camshaft Position Actuator Adjuster Replacement .




Note: Do not damage the sealing surfaces.

2. Use the EN-45000 remover to loosen the camshaft front oil seals (1).



3. Remove the camshaft front oil seals (1).

1. Insert 2 NEW camshaft front oil seals (1).



2. Tighten the seal ring with EN-422 installer (3) on the camshaft until this is in contact with the cylinder head.
3. To install, use camshaft sprocket bolt (1) in conjunction with shims (2) with a total thickness of approximately 10 mm (0.393 in).
4. Install the camshaft position actuator adjuster. Refer to Camshaft Position Actuator Adjuster Replacement .