Orlando

Timing Belt Inspection — LDE, LED, LFJ, LXV, 2H0, LUW, LFH

Special Tools

For equivalent regional tools, refer to Special Tools .

1. Remove the timing belt upper front cover. Refer to Timing Belt Upper Front Cover Removal : LDE, LED, LFJ, LXV, 2H0, LUW, LFH .



2. Set the crankshaft balancer in the direction of the engine rotation to "1st cylinder TDC" (mark 1).
3. Remove the camshaft cover. Refer to Camshaft Cover Removal .




Note: The right half of the EN-6340 locking tool can be recognised by the lettering "right", arrow, on the tool.

4. Prepare the right half of the EN-6340 locking tool.

4.1.	Remove the 2 bolts (2).

4.2.	Remove the front panel (1) from the EN-6340 locking tool -right.





Note: 

•	The spot type marking (4) on the intake camshaft position actuator adjuster does not correspond to the groove of the EN-6340 locking tool - left (1) during this process, but must be somewhat above.

•	The spot type marking (3) on the exhaust camshaft position actuator adjuster must correspond to the groove on EN-6340 locking tool - right (2).

5. Insert the EN-6340 locking tool - left (1) and the EN-6340 locking tool - right (2) in the camshaft position actuator adjuster.




Note: If the EN-6628-A locking tool cannot be inserted, the timing must be set.

6. Align the camshafts horizontally by the hexagon (arrows) until the EN-6628-A locking tool can be inserted in both camshafts.



7. Insert the EN-6628-A locking tool (1) into the camshafts.

1. Remove the EN-6628-A locking tool.
2. Remove the EN-6340 locking tool.
3. Install the camshaft cover. Refer to Camshaft Cover Installation .
4. Install the timing belt upper front cover. Refer to Timing Belt Upper Front Cover Installation : LDE, LED, LFJ, LXV, 2H0, LUW, LFH .