Service Information

Orlando

Front Differential Assembly Installation

Table 1:	Front Differential Installation
Table 2:	Front Differential Bearing Cup Installation
Table 3:	Front Differential Bearing Adjuster Lock Installation

Callout	Component Name
1	Front Differential
2	Front Differential Bearing Adjuster - Right Side
3	Front Differential Bearing Adjuster Bolts - Right Side (Qty: 5) Caution: Refer to Fastener Caution in the Preface section. Tighten 25 N·m (18 lb ft)

Callout

Component Name

Front Differential

Front Differential Bearing Adjuster - Right Side

Front Differential Bearing Adjuster Bolts - Right Side (Qty: 5)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
25 N·m (18 lb ft)

Callout

Component Name

Front Differential Bearing Cup

Tighten the front bearing differential cup until there is no end play with the differential.
Tighten or loosen the front bearing differential cup to get the required preload on the bearings.

•	Used Bearings: 1 N·m (9 lb in) is required to rotate the differential one revolution per second.

•	New Bearings: 2 N·m (18 lb in) is required to rotate the differential one revolution per second.

DT-520 Remover/Installer

Callout	Component Name
1	Front Differential Bearing Adjuster Lock
2	Front Differential Bearing Adjuster Lock Bolt Caution: Refer to Fastener Caution in the Preface section. Tighten 9 N·m (80 lb in)

Callout

Component Name

Front Differential Bearing Adjuster Lock

Front Differential Bearing Adjuster Lock Bolt

Caution: Refer to Fastener Caution in the Preface section.

Tighten
9 N·m (80 lb in)