Orlando

Transmission Mount Replacement - Left Side

Special Tools

For equivalent regional tools, refer to Special Tools .

1. Remove the battery tray. Refer to Battery Tray Replacement .
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .




Note: The SPX installation manual is supplied with the special tool and is also available online from SPX directly. Go to www.spxtools-shop.com.

3. Assemble the CH-49290 support tool (1) according to the details provided in the SPX installation manual.
4. Support the CH-904 base frame on a jack.
5. Support the CH-49290 support tool on the CH-904 base frame.




Note: The SPX installation manual is supplied with the special tool and is also available online from SPX directly. Go to www.spxtools-shop.com.

6. Install the CH-49290 support tool (1) according to the details provided in the SPX installation manual.
7. Lower the vehicle.



8. Remove and DISCARD the left transmission mount bolts (1) from the transmission mount bracket (2).



9. Remove the left transmission mount to body bolts (1).
10. Remove the left transmission mount to body nut (2).
11. Remove the transmission mount (3) from the vehicle.

1. Install the transmission mount (3) to the vehicle.

Caution: Refer to Fastener Caution in the Preface section.

Caution: Refer to Torque-to-Yield Fastener Caution in the Preface section.

2. Install the transmission mount to body bolts (1) and tighten to 62 N·m (46 lb ft).
3. Install the transmission mount to body nut (2) and tighten to 62 N·m (46 lb ft).



4. Install the 3 NEW left transmission mount bolts (1) to the transmission mount bracket (2) and tighten a first pass to 50 N·m (37 lb ft).
5. Tighten the 3 NEW transmission mount bolts (1) a final pass to an additional 60 - 70 degrees, using the EN-45095 meter .
6. Raise the vehicle.



7. Lower the CH-49290 support tool (1) with the CH-904 base frame and a jack.
8. Remove the CH-49290 support tool from the CH-904 base frame.




Note: The SPX installation manual is supplied with the special tool and is also available online from SPX directly. Go to www.spxtools-shop.com.

9. Disassemble the CH-49290 support tool (1) according to the details provided in the SPX installation manual.
10. Lower the vehicle.
11. Install the battery tray. Refer to Battery Tray Replacement .