Orlando

Ignition Coil Installation

Special Tools

EN-6009 Remover/Installer Ignition Module

For equivalent regional tools, refer to Special Tools .

1. Install the ignition coil module (2) with the EN-6009 remover/installer (1).
2. Remove the EN-6009 remover/installer (1).

Caution: Refer to Fastener Caution in the Preface section.

Note: Note the arrow on the cover.

3. Install the 2 ignition coil bolts an tighten to 8 N·m (71 lb in).

Note: Note the arrow on the cover.

4. Install the cover of the DIS ignition coil against the direction of the arrow.