Orlando |
||||||||
|
|
|
|||||||
Illustration | Tool Number/Description |
|---|---|
| GE-328-B KM-328-B Remover |
| EN-422 KM-422 83 94 959 Installer |
| GE-21867-A J-21867-A KM-498-B Pressure Gauge and Adapter Set |
| GE-571-B MKM-571-B J-8001 Dial Gauge |
| EN-652 KM-652 Flywheel Holder / To fix flywheel, when transmission is removed |
| EN-796 KM-796-A Dismantler |
| CH-807 KM-807 Closure Plugs / Sealing opened quick fittings, gasoline line |
| EN-840 KM-840 J-36017 83 94 157 Remover / Removing the valve stem seal |
| EN-845 KM-845 Suction Device / Removing and installing flat-base tappet |
| EN-849 KM-849 Assembly Tray / For piston, con-rod, valves, valves spring, valves lifter |
| EN-958 KM-958 Valve Stem Seal Installer |
| EN-6009 KM-6009 83 96 335 Remover/Installer |
| EN-6086 MKM-6086 Basic Kit, Spring and Wedge Replacer |
| EN-6167 KM-6167 Counter Holder Adapter Set |
| EN-6171 KM-6171 Release Tool |
| EN-6215 KM-6215 Mounting Equipment |
| EN-6333 KM-6333 Locking Pin / To secure timing belt tensioner in position |
| EN-6340 KM-6340 Locking Tool / To hold the camshaft sprockets or adjuster for checking and adjusting valve times |
| EN-6349 KM-6349 Locking Pin / To fix the drive belt tensioner |
| EN-6351 KM-6351 Assembly Sleeves / To install crankshaft front seal ring |
| EN-6361 KM-6361 Feeler Gauge Set |
| EN-6623 KM-6623 Installer / To install the rear crankshaft seal |
| EN-6624 KM-6624 Remover / To remove the rear crankshaft seal |
| EN-6625 KM-6625 Flywheel Locking Device / To block flywheel, when transmission is mounted |
| EN-6628-A KM-6628-A Locking Tool / To fix the camshafts in top dead position for checking and adjustment the valve timing |
| EN-8087 J-8087 Cylinder Bore Gauge / Used to measure cylinder bore |
| GE-22738-B J-22738-B Valve Spring Tester |
| EN-34730-91 KM-J-34730-91 Pressure Tester |
| J-37088-A KM-J-37088A Fuel Line Disconnect Tool Set |
| EN-45000 KM-J-45000 J-45000 Seal Remover |
| EN-45059 J-45059 Torque angle sensor kit / To tighten anti-fatigue bolts according to angle |
| EN 47649 Engine Bridge |
| EN 47650 Carrier Frame |
| EN 47650-030 Extensions for Retainer Frame |
| EN 47650-050 Mounting Rail for Engine Bridge EN-47649 |
| EN 47650-250 Adaption Carrier Frame Engine Bridge Front |
| EN 47650-300 Adapter for Engine Bridge Retainer Frame |
| CH 49290 Mounting Engine/Transmission |
| CH-49800 EN-50098 Power Steering Pump Belt Installer |
| © Copyright Chevrolet. All rights reserved |
