To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Input Speed Sensor Replacement

Removal Procedure

  1. Remove the control valve body. Refer to Control Valve Body Replacement .

  2. 1998841
  3. Remove the input speed sensor bolt (2) M6 x 23.
  4. Unlock the 2 retaining tabs inside the transmission housing.
  5. Remove the input speed sensor (3).
  6. Remove the 3 input speed sensor seals (1).

Installation Procedure


    1998841
  1. Install the 3 input speed sensor seals (1).
  2. Install the input speed sensor (3).
  3. Verify that the retaining tabs are locked completely.
  4. Caution: Refer to Fastener Caution in the Preface section.

  5. Install the input speed sensor bolt (2) M6 x 23 and tighten to 9 N·m (80 lb in).
  6. Install the control valve body. Refer to Control Valve Body Replacement .
  7. Perform the transmission adaptive values learn procedure. Refer to Transmission Adaptive Values Learn .
   


© Copyright Chevrolet. All rights reserved