Orlando

Control Solenoid Valve and Transmission Control Module Assembly Programming and Setup — 6T30/6T40/6T45/6T50

The following service procedures require either a programming or a setup event performed for a complete repair. The transmission control module (TCM) is part of the control solenoid valve assembly, and is not serviced separately.

If the TCM is replaced, the following procedures must be performed:

1. TCM Reprogramming
2. The Transmission Adaptive Values Learn. Refer to Transmission Adaptive Values Learn .

Note: Use a scan tool to view and record the Transmission Control Module - End Model Part Number in the original TCM prior to starting the TCM reprogramming procedure.

1. If the TCM needs to be reprogrammed. Refer to Service Programming System (SPS) .
2. Perform the Transmission Adaptive Values Learn. Refer to Transmission Adaptive Values Learn .

Note: After programming, perform the following to avoid future misdiagnosis:

1. Turn the ignition OFF for 30 seconds.
2. Turn the ignition ON with the engine OFF.
3. Use the scan tool in order to retrieve history DTCs from all modules.
4. Clear all history DTCs.

The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, the Transmission Adaptive Values Learn procedure must be performed:

Refer to Transmission Adaptive Values Learn .