To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Cruise Control Malfunction

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

B+ Voltage Reference

1

B3794 08

B3794 59

B3794 08

Cruise Control Switch Signal

1

B3794 08

B3794 01

B3794 08

1. Cruise Control Malfunction

Circuit/System Description

The cruise control switch is an input to the body control module (BCM). The BCM monitors the cruise control on/off, set/coast, resume/accelerate and cancel switches via the cruise control switch signal circuit in order to detect when the driver has requested to perform a cruise control function. The BCM detects a specific voltage signal on the cruise control switch signal circuit when a switch is applied. The engine control module (ECM) receives the requested cruise control switch function from the BCM via a serial data message.

Reference Information

Schematic Reference

Cruise Control Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Cruise Control Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

Engine ON, while rotating the steering wheel to both steering stops, observe the scan tool Cruise Control Switch parameter while pressing each of the cruise control switches. The parameter should toggle between On, Off, Resume and Set as the applicable switch is pressed.

Circuit/System Testing

  1. Ignition OFF, disconnect the wiring harness plug at the S70L Steering Wheel Controls Switch - Left.
  2. Ignition ON, test for 11.0 V between the voltage reference circuit terminal 1 and ground.
  3. If less than the specified value, test the reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.
  4. Test for 11.0 V between the voltage reference circuit terminal 1 and the signal circuit terminal 3.
  5. If less than the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.
  6. Ignition OFF, disconnect the X3 harness connector at the K9 Body Control Module.
  7. Test for infinite resistance between the signal circuit terminal 9 and ground.
  8. If less than the specified value, test the signal circuit for a short to ground.
  9. If all circuits test normal, test or replace the S70L Steering Wheel Controls Switch - Left.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Cruise Control Switch Replacement
    • Control Module References for BCM replacement, setup and programming
   


© Copyright Chevrolet. All rights reserved