Orlando

Starter Solenoid Clicks, Engine Does Not Crank

Schematic Reference

Starting and Charging Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Starting System Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

1. Ignition OFF, measure and record the battery voltage at the battery terminals. The voltage should be between 12.0-15.0 V.

⇒	If not within the specified range, refer to Battery Charging .

2. Remove the drive belts. Refer to Drive Belt Replacement for LNP engine or Drive Belt Replacement for 2H0 engine.
3. Place the S39 Ignition Switch to the CRANK position.

⇒	If the engine cranks, inspect the engine and belt drive system for mechanical binding, seized engine, or seized generator, etc.

⇒	If the engine does not crank, refer to Engine Will Not Crank - Crankshaft Will Not Rotate .

4. Test for less than 0.5 V between the positive battery cable and terminal A X2 at the M64 Starter Motor as the ignition switch is set to the START position.

⇒	If greater than the specified value, replace the positive battery cable.

5. Test for less than 0.5 V between the negative battery cable and the starter motor case as the ignition switch is placed to the START position.

⇒	If greater than the specified value, replace the negative battery cable.

6. If all circuits test normal, replace the M64 Starter Motor.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.