Orlando

DTC P2147, P2148, P2150, or P2151 — LNP or LNQ

The engine control module (ECM) supplies voltage to each fuel injector on the injector positive voltage control circuits. The ECM energises each fuel injector by grounding the control circuit of that fuel injector. The ECM monitors the status of the injector positive voltage control circuits and the fuel injector control circuits. The injectors are separated into the following two groups:

When a fuel injector circuit condition is detected by the ECM, the affected fuel injector will be disabled and may disable the affected group of fuel injectors.

The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match.

DTCs P2147 00, P2148 00, P2150 00 and P2151 00 are Type A DTCs.

DTCs P2147 00, P2148 00, P2150 00 and P2151 00 are Type A DTCs.

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

1. Ignition ON, observe the DTC information with a scan tool. DTCs P0201 00, P0202 00, P0203 00 or P0204 00 should not set.

⇒	If any DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .

2. Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that are captured in the freeze frame/failure records Data List.

1. Ignition OFF, disconnect the harness connector at the affected fuel injector.
2. Ignition ON, test for 2.0-2.5 V between the control circuit terminal 1 and ground.

⇒	If less than the specified range, test the control circuit for an open/high resistance or for a short to ground. If the circuit tests normal, replace the K20 Engine Control Module.

⇒	If greater than the specified range, test the control circuit for a short to voltage. If the circuit tests normal, replace the K20 Engine Control Module.

3. Ignition OFF, disconnect the harness connector X1 at the K20 Engine Control Module.
4. Test for less than 5 Ω between the affected fuel injector low control circuit terminal 2 and the K20 Engine Control Module terminal as listed below:

•	Terminal 26 for injector 1

•	Terminal 74 for injector 2

•	Terminal 75 for injector 3

•	Terminal 25 for injector 4

⇒	If greater than the specified range, test the low control circuit for an open/high resistance

5. If all circuits test normal, perform the Component Testing before replacing the K20 Engine Control Module.

Static Test

1. Disconnect the harness connector at the appropriate Q17 Fuel Injector.

Note: The DMM and test leads must be calibrated to 0 Ω in order to prevent misdiagnosis.

2. Test for 0.2-0.7 Ω between the low control terminal 2 and the high control terminal 1.

⇒	If not within the specified range, replace the appropriate Q17 Fuel Injector.

3. Test for infinite resistance between each terminal and ground.

⇒	If not the specified value, replace the appropriate Q17 Fuel Injector.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.