To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Front Bumper Fascia Removal and Installation


2373449

Callout

Component Name

Preliminary Procedures

  1. Remove the front wing wheel opening moulding. Refer to Front Wing Wheel Opening Moulding Replacement .
  2. Remove the radiator opening upper cover. Refer to Radiator Opening Upper Cover Replacement .

1

Front Bumper Fascia Upper Retainer (Qty: 2)

2

Front Bumper Fascia Bolt (Qty: 2)

Caution : Refer to Fastener Caution in the Preface section.

Tighten
9 N·m (80 lb in)

3

Front Wheelhouse Liner Bolt (Qty: 2)

4

Front Wheelhouse Liner Bolt (Qty: 2)

Procedure

To remove the bolts, partially loosen the front wheelhouse liner.

5

Front Wheelhouse Liner Bolt (Qty: 6)

6

Front Bumper Lower Stiffener Bolt

Tighten
25 N·m (18 lb ft)

7

Front Bumper Fascia Lower Retainer (Qty: 4)

8

Front Bumper Fascia

Procedure

  1. Insert flat bladed plastic trim tool to release the retainer for the front bumper fascia guides.
  2. Use care, fascia will rip apart if forced.
  3. Unclip from front bumper fascia guides.
  4. Pull forward to remove the front bumper fascia.
  5. Disconnect any electrical connectors.
   


© Copyright Chevrolet. All rights reserved