To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Bonnet Adjustment


2373510

Callout

Component Name

1

Bonnet

Caution : Refer to Fastener Caution in the Preface section.

Procedure

  1. Loosen the bonnet hinge reinforcement nuts (Qty: 4).
  2. Adjust the bonnet in order to obtain an even gap on both sides between the bonnet and the wings, the headlamps and the front bumper fascia and so that the bonnet is flush with both wings on the front edge, the front bumper fascia and the headlamps.

Adjustment

    • Bonnet to wing
        (a) 3 mm ± 0.75 mm (0.12 in ± 0.03 in)
    • Bonnet to headlight
        (b) 3 mm ± 1 mm (0.12 in ± 0.04 in
    • Bonnet to front bumper fascia
        (c) 5 mm ± 1 mm (0.2 in ± 0.04 in)
    • Bonnet to front bumper fascia
        (d) 5 mm ± 1 mm (0.2 in ± 0.04 in)

Tighten
22 N·m (16 lb ft)

   


© Copyright Chevrolet. All rights reserved