Orlando

Front Seat Cushion Cover and Pad Replacement

Warning: Refer to SIR Warning in the Preface section.

Warning: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. The bladder, the pressure sensor, the seat cushion, and the control module are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.

1. Remove the driver or passenger seat. Refer to Driver or Passenger Seat Replacement .
2. Remove the front seat cushion inner trim panel. Refer to Front Seat Cushion Inner Trim Panel Replacement .
3. Remove the front seat cushion outer trim panel. Refer to Front Seat Cushion Outer Trim Panel Replacement .



4. Detach cushion cover from backrest below.
5. Release and disconnect wiring harness plug (1), if equipped.
6. Remove 4 front seat backrest screws (2).
7. Remove backrest.



8. Detach cushion cover (1) from seat frame (3) all the way round.
9. Remove cushion cover with pad from frame.
10. Remove cushion cover from pad (2).

1. Install cushion cover (1) to pad (2).
2. Install cushion cover with pad to frame (3).
3. Attach cushion cover to seat frame all the way round.



4. Install backrest.

Caution: Refer to Fastener Caution in the Preface section.

5. Tighten 4 front seat backrest screws (2). 35 N·m (26 lb ft)
6. Connect and catch wiring harness plug (1), if equipped.
7. Attach cushion cover to backrest below.
8. Install the front seat cushion outer trim panel. Refer to Front Seat Cushion Outer Trim Panel Replacement .
9. Install the front seat cushion inner trim panel. Refer to Front Seat Cushion Inner Trim Panel Replacement .
10. Install the driver or passenger seat. Refer to Driver or Passenger Seat Replacement .