Orlando

Master Cylinder Replacement - Left Hand Drive

Warning: Refer to Brake Fluid Irritant Warning in the Preface section.

Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution in the Preface section.

1. Remove dash upper extension panel opening cover. Refer to Dash Upper Extension Panel Opening Cover Replacement .
2. Remove battery tray. Refer to Battery Tray Replacement .




Note: Do NOT disconnect engine coolant hoses.

3. Remove the radiator surge tank clip (2).
4. Remove the radiator expansion tank (1) without draining.

Position the radiator surge tank (1) aside.

5. Disconnect the brake fluid level indicator switch electrical connector and separate from brake fluid reservoir.



6. Disconnect the master cylinder secondary brake pipe fitting (1).

Cap the brake pipe fitting and plug the master cylinder outlet port to prevent brake fluid loss and contamination.




7. Disconnect the master cylinder primary brake pipe fitting (1).

Cap the brake pipe fitting and plug the master cylinder outlet port to prevent brake fluid loss and contamination.




8. Remove and DISCARD master cylinder nuts (1).
9. Remove master cylinder with brake fluid reservoir.
10. Inspect the master cylinder to vacuum brake booster seal for damage and replace, if necessary.
11. Remove the master cylinder reservoir, if necessary. Refer to Master Cylinder Reservoir Replacement .

1. Install the brake fluid reservoir to master cylinder. Refer to Master Cylinder Reservoir Replacement .
2. Ensure the master cylinder to vacuum brake booster seal is properly seated on the master cylinder barrel.
3. Perform the master cylinder bench bleeding. Refer to Master Cylinder Bench Bleeding .

Warning: Refer to Torque-to-Yield Fastener Warning in the Preface section.

Caution: Refer to Fastener Caution in the Preface section.




4. Install NEW master cylinder nuts (1) and tighten to 50 N·m (37 lb ft).
5. Install the brake fluid level indicator switch harness to the brake fluid reservoir and connect the electrical connector.



6. Connect the master cylinder primary brake pipe fitting (1) and tighten to 18 N·m (13 lb ft).



7. Connect the master cylinder secondary brake pipe fitting (1) and tighten to 18 N·m (13 lb ft).



8. Install the radiator surge tank (1.)
9. Install the radiator surge tank clip (2).
10. Install the battery tray. Refer to Battery Tray Replacement .
11. Install dash upper extension panel opening cover. Refer to Dash Upper Extension Panel Opening Cover Replacement .
12. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding .