Orlando

Belt Idler Pulley Replacement - Lower

Special Tools

EN-48952 Fixing Pin

For equivalent regional tools, refer to Special Tools .

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the front compartment insulator. Refer to Front Compartment Insulator Replacement .
3. Remove the front part of the right front wheelhousing lining. Refer to Front Wheelhouse Liner Replacement .
4. Remove the drive belt and pulley cover. Refer to Drive Belt and Pulley Cover Removal .



5. Apply tension to the drive belt tensioner (1) with a suitable spanner on the holder (2) by rotating anti-clockwise.
6. Install the EN-48952 fixing pin (3).
7. Remove the drive belt from the drive belt tensioner.



8. Remove the lower drive belt idler pulley bolt (2).
9. Remove the lower drive belt idler pulley (1).

1. Install the lower drive belt idler pulley (1).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the lower drive belt idler pulley bolt (2) and tighten to 58 N·m (43 lb ft).
3. Install the drive belt to the drive belt tensioner.



4. Apply tension to the drive belt tensioner (1) with a suitable spanner on the holder (2) by rotating anti-clockwise.
5. Remove the EN-48952 fixing pin (3).
6. Relieve tension from the drive belt tensioner (1) and allow the tensioner to slide back slowly.
7. Inspect the drive belt for correct seat.
8. Install the drive belt and pulley cover. Refer to Drive Belt and Pulley Cover Installation .
9. Install the front part of the right front wheelhousing lining. Refer to Front Wheelhouse Liner Replacement .
10. Install the front compartment insulator. Refer to Front Compartment Insulator Replacement .
11. Lower the vehicle.