To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Crankshaft Rear Oil Seal Replacement

Special Tools

    • EN-45000 Remover - Oil Seal
    • EN-48251 Installer - Crankshaft Rear Oil Seal

For equivalent regional tools, refer to Special Tools .

Removal Procedure

  1. Remove the engine flywheel / automatic transmission flexplate.
  2. • Manual Transmission, refer to Engine Flywheel Replacement .
    • Automatic Transmission, refer to Automatic Transmission Flex Plate Replacement .

    2373405

    Note: Be careful do not damage the sealing surfaces.

  3. Remove the crankshaft front oil seal (1), using the EN-45000 remover .

Installation Procedure


    2373477
  1. Install the crankshaft rear oil seal ring (1), using the EN-48251 installer (2).
  2. Install the engine flywheel / automatic transmission flexplate.
  3. • Manual transmission, refer to Engine Flywheel Replacement .
    • Automatic transmission, refer to Automatic Transmission Flex Plate Replacement .
   


© Copyright Chevrolet. All rights reserved