To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Heated Oxygen Sensor Replacement

Special Tools

EN-48259 Remover - Oxygen Sensor

For equivalent regional tools, refer to Special Tools .

Removal Procedure


    2373116
  1. Disconnect the heated oxygen sensor wiring harness plug.
  2. Remove the heated oxygen sensor (1), using the EN-48259 remover .

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    2373116
  1. Install the heated oxygen sensor (1), using the EN-48259 installer and tighten to 50 N·m (37 lb ft).
  2. Connect the heated oxygen sensor wiring harness plug .
   


© Copyright Chevrolet. All rights reserved