Orlando

Starter Replacement — 2.0L Diesel LNP with MT

1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the front compartment insulator. Refer to Front Compartment Insulator Replacement .
4. Remove the transmission rear mount. Refer to Transmission Rear Mount Replacement : Hydraulic Power Steering .



5. Disconnect the starter wiring harness plug (1).
6. Remove the positive starter cable nut (2) and the positive starter cable (5).
7. Remove the ground cable retaining bolt (4) and the ground cable (3) from the engine block.



8. Remove the engine wiring harness bracket retaining nut (2) and remove the engine wiring harness (1).



9. Remove the 3 starter retaining bolts (1, 3).
10. Remove the starter (2).

1. Install the starter (2).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the 3 starter retaining bolts (1, 3) and tighten to 58 N·m (43 lb ft).



3. Install the engine wiring harness (1) and the engine wiring harness bracket retaining nut (2) and tighten to 9.5 N·m (84 lb in).



4. Connect the starter wiring harness plug (1).
5. Install the positive starter cable (5) and the positive starter cable nut (2). Tighten the nut to 9,5 N·m (84 lb in).
6. Install the ground cable (3) and the ground cable retaining bolt (4) to the engine block. Tighten the bolt to 22 N·m (16 lb ft).
7. Install the transmission rear mount. Refer to Transmission Rear Mount Replacement : Hydraulic Power Steering .
8. Install the front compartment insulator. Refer to Front Compartment Insulator Replacement .
9. Lower the vehicle.
10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .