Orlando

Exhaust Pipe Front Hanger Bracket Replacement — 2.0L Diesel LNP

Warning: Refer to Exhaust Service Warning in the Preface section.

Warning: Refer to Protective Goggles and Glove Warning in the Preface section.

Caution: Do not bend the exhaust flex pipe more than 10 degrees in any direction. Bending of more than 10 degrees or twisting in a range of ±0.5 degrees will damage the exhaust flex decoupler.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .



2. Support the exhaust front pipe (1).
3. Remove the 2 exhaust front pipe hanger bracket bolts (4) and the 2 drive frame bolts (3).
4. Remove the 2 exhaust front pipe hanger insulator nuts (5).
5. Remove the exhaust front pipe hanger bracket (6) from the exhaust front pipe hanger insulators (2).

1. Install the exhaust front pipe hanger bracket (6) to the exhaust front pipe hanger insulators (2).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the 2 exhaust front pipe hanger insulator nuts (5) and tighten the nuts to 22 N·m (16 lb ft).
3. Install the 2 drive frame bolts M10 (3) and tighten the bolts to 60 N·m + 30° - 45° (44 lb ft) + 30° - 45°.
4. Install the 2 exhaust front pipe hanger bracket bolts M8 (4) and tighten the bolts to 22 N·m (17 lb ft).
5. Remove the support from the exhaust front pipe (1).
6. Lower the vehicle.