To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Exhaust Manifold Heat Shield Replacement — 2.0L Diesel LNP

Removal Procedure

    Warning: Refer to Exhaust Service Warning in the Preface section.

    Warning: Refer to Protective Goggles and Glove Warning in the Preface section.

    Caution: Do not bend the exhaust flex pipe more than 10 degrees in any direction. Bending of more than 10 degrees or twisting in a range of ±0.5 degrees will damage the exhaust flex decoupler.

  1. Remove the turbocharger. Refer to Turbocharger Replacement .

  2. 2373129
  3. Remove 3 exhaust manifold heat shield bolts (1).
  4. Remove the exhaust manifold heat shield (2).

Installation Procedure


    2373129
  1. Install the exhaust manifold heat shield (2).
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the exhaust manifold heat shield bolts (1) and tighten the bolts to 10 N·m (89 lb in).
  4. Install the turbocharger. Refer to Turbocharger Replacement .
   


© Copyright Chevrolet. All rights reserved