Orlando

Fuel Injection Pump Installation

Special Tools

EN-50434 Dust Cap - Fuel Rail Port

For equivalent regional tools, refer to Special Tools .

Note: Do not tilt the fuel injection pump actuator at the inlet camshaft.

1. Install the fuel injection pump (1).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the 3 fuel injection pump retaining bolts (2) and tighten to 22 N·m (16 lb ft).
3. Remove the EN-50434 dust cap .



4. Install the fuel feed pipe (1).
5. Install 2 fuel injection fuel feed pipe nuts to the fuel feed rail and the fuel injection pump. Tighten the fuel pipe nuts to 27 N·m (20 lb ft).