To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Inlet Air Pressure and Temperature Sensor Replacement

Removal Procedure
  1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .

    2. 2511758
  2. Disconnect the inlet air pressure/temperature sensor wiring harness plug (3).
  3. Remove the inlet air pressure/temperature sensor bolt (2).
  4. Remove the inlet air pressure/temperature sensor (1) and the gasket (4).

Installation Procedure

    2511758
  1. Install the inlet air pressure/temperature sensor (1) and a NEW gasket (4).

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the inlet air pressure/temperature sensor bolt (2) and tighten to 9 N·m (80 lb in).
  3. Connect the inlet air pressure/temperature sensor wiring harness plug (3).
  4. Install the engine sight shield. Refer to Engine Sight Shield Replacement .
   


© Copyright Chevrolet. All rights reserved