To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Exhaust Gas Recirculation Pipe Replacement

Removal Procedure

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .
  2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  3. Remove front compartment insulator. Refer to Front Compartment Insulator Replacement .

  4. 2373159
  5. Remove the 4 exhaust gas recirculation bolts (3).
  6. Remove the exhaust gas recirculation pipe (2) along with the gaskets (1, 4).

Installation Procedure


    2373159

    Note: Clean the sealing surfaces.

  1. Install the exhaust gas recirculation pipe (2) along with NEW gaskets (1, 4).
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the 4 exhaust gas recirculation bolts (3) and tighten to 10 N·m (89 lb in).
  4. Install front compartment insulator. Refer to Front Compartment Insulator Replacement .
  5. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .
   


© Copyright Chevrolet. All rights reserved