Orlando

Exhaust Temperature Sensor Replacement - Position 1

Special Tools

EN-50429 Adaptor Exhaust Temperature Sensor Remover/Installer

For equivalent regional tools, refer to Special Tools .

1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
2. Remove the turbocharger heat shield. Refer to Turbocharger Heat Shield Replacement .
3. Remove the positive crankcase ventilation hose. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replacement .
4. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .



5. Disconnect the exhaust temperature sensor wiring harness plug position 1 from the engine wiring harness.
6. Remove the exhaust temperature sensor position 1 (2) from the turbocharger (1), using the EN-50429 adaptor .

Caution: Refer to Fastener Caution in the Preface section.




1. Install the exhaust temperature sensor position 1 (2) to the turbocharger (1), using the EN-50429 adaptor . Tighten the exhaust temperature sensor position 1 (2) to 45 N·m (33 lb ft).
2. Connect the exhaust temperature sensor wiring harness plug position 1 to the engine wiring harness.
3. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
4. Install the positive crankcase ventilation hose. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replacement .
5. Install the turbocharger heat shield. Refer to Turbocharger Heat Shield Replacement .
6. Install the engine sight shield. Refer to Engine Sight Shield Replacement .