Orlando

Exhaust Temperature Sensor Replacement - Position 2

Special Tools

EN-50429 Adaptor Exhaust Temperature Sensor Remover/Installer

For equivalent regional tools, refer to Special Tools .

1. Disconnect and unclip the exhaust temperature sensor wiring harness plug (2) from the exhaust pressure sensor bracket.
2. Remove the exhaust temperature sensor position 2 (1) with the EN-50429 adaptor .

Caution: Refer to Fastener Caution in the Preface section.




1. Install the exhaust temperature sensor position 2 (1) with the EN-50429 adaptor and tighten to 45 N·m (33 lb ft).
2. Connect and clip in the exhaust temperature sensor wiring harness plug (2) to the exhaust pressure sensor bracket.