To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Clutch Actuator Cylinder Front Pipe Replacement — D16, D20, and Left Hand Drive

Removal Procedure

  1. Remove the battery tray. Refer to Battery Tray Replacement .
  2. Note: Do NOT disconnect engine coolant hoses.

  3. Remove the radiator surge tank. Refer to Radiator Surge Tank Replacement .
  4. Position the radiator surge tank aside.

  5. 2028033

    Note: Before disconnecting the clutch actuator cylinder front pipe, remove the clutch/brake fluid from the reservoir tank.

  6. Remove the clutch actuator cylinder front pipe retainer (1, 4).
  7. Remove the clutch actuator cylinder front pipe from the retainer (3).
  8. Remove the clutch actuator cylinder front pipe (2).

Installation Procedure


    2028033
  1. Install the clutch actuator cylinder front pipe (2).
  2. Install the clutch actuator cylinder front pipe to the retainer (3).
  3. Install the clutch actuator cylinder front pipe retainer (1, 4).
  4. Bleed the hydraulic clutch system. Refer to Hydraulic Clutch System Bleeding .
  5. Fill the reservoir with clutch/brake fluid up to the MAX level.
  6. Install the radiator surge tank. Refer to Radiator Surge Tank Replacement .
  7. Install the battery tray. Refer to Battery Tray Replacement .
   


© Copyright Chevrolet. All rights reserved