Orlando

Exhaust Temperature Sensor Replacement - Position 3

Special Tools

EN-50429 Adaptor Exhaust Temperature Sensor Remover/Installer

For equivalent regional tools, refer to Special Tools .

1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
2. Remove the 2 charge air cooler inlet air hose nuts. Hang the charge air cooler inlet air hose aside.



3. Disconnect and unclip the exhaust temperature sensor wiring harness plug from the charge air control vacuum pipe (1).
4. Remove the exhaust temperature sensor position 3 (2), using the EN-50429 adaptor .

Caution: Refer to Fastener Caution in the Preface section.




1. Install the exhaust temperature sensor position 3 (2) and tighten to 45 N·m (33 lb ft), using the EN-50429 adaptor .
2. Connect and clip in the exhaust temperature sensor wiring harness to the charge air control vacuum pipe (1).
3. Install the 2 charge air cooler inlet air hose nuts and tighten to 22 N·m (16 lb ft).
4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .