To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Engine Oil Cooler Outlet Hose Replacement — 2.0L Diesel LNP

Removal Procedure

  1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
  2. Remove the battery tray. Refer to Battery Tray Replacement .
  3. Remove the engine control module. Refer to Engine Control Module Replacement .
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the front compartment insulator. Refer to Front Compartment Insulator Replacement .
  6. Drain the cooling system. Refer to Cooling System Draining and Filling .

  7. 2511704
  8. Remove the engine oil cooler outlet hose clip (2) and the engine oil cooler outlet hose (3) from the engine oil cooler (1).
  9. Lower the vehicle.
  10. Remove the charge air cooler outlet rear hose from the throttle body and the charge air cooler outlet front hose from the charge air cooler outlet front hose bracket and hang it aside. Refer to Charge Air Cooler Outlet Hose Replacement : LNP and Manual Transmission → LNP and Automatic Transmission .
  11. Remove the throttle body. Refer to Throttle Body Assembly Replacement .

  12. 2511706
  13. Remove the engine oil cooler outlet hose clip (2) and the engine oil cooler outlet hose (3) from the thermostat bypass pipe (1).
  14. Remove the engine oil cooler outlet hose (3).

Installation Procedure


    2511706
  1. Reposition the engine oil cooler outlet hose (3).
  2. Install the engine oil cooler outlet hose (3) with the engine oil cooler outlet hose clip (2) to the thermostat bypass pipe (1).
  3. Install the throttle body. Refer to Throttle Body Assembly Replacement .
  4. Install the charge air cooler outlet rear hose to the throttle body and the charge air cooler outlet front hose to the charge air cooler outlet front hose bracket. Refer to Charge Air Cooler Outlet Hose Replacement : LNP and Manual Transmission → LNP and Automatic Transmission .
  5. Raise the vehicle.

  6. 2511704
  7. Install the engine oil cooler outlet hose (3) with the engine oil cooler outlet hose clip (2) to the engine oil cooler (1).
  8. Install the front compartment insulator. Refer to Front Compartment Insulator Replacement .
  9. Lower the vehicle.
  10. Fill the cooling system. Refer to Cooling System Draining and Filling .
  11. Install the engine control module. Refer to Engine Control Module Replacement .
  12. Install the battery tray. Refer to Battery Tray Replacement .
  13. Install the engine sight shield. Refer to Engine Sight Shield Replacement .
   


© Copyright Chevrolet. All rights reserved