To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Turbocharger Oil Return Pipe Replacement

Removal Procedure

  1. Remove the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .
  2. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
  3. Remove the charge air cooler inlet hose Charge Air Cooler Inlet Hose Replacement : 2.0L Diesel LNP .
  4. Remove the exhaust particulate filter. Refer to Exhaust Particulate Filter Removal .

  5. 2373123
  6. Remove the 2 turbocharger bracket bolts (1).
  7. Remove the turbocharger bracket (2).

  8. 2373128
  9. Remove the 4 turbocharger oil return pipe bolts (4).
  10. Remove the turbocharger oil return pipe (2) and the 2 turbocharger oil return pipe gaskets (1, 3).

Installation Procedure


    2373128
  1. Install the turbocharger oil return pipe (2) and 2 NEW gaskets (1, 3).
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the 4 turbocharger oil return pipe bolts (4) and tighten to 10 N·m (89 lb in).

  4. 2373123
  5. Install the turbocharger bracket (2).
  6. Install the 2 bolts (1) to the turbocharger bracket (2) and tighten to 25 N·m (18 lb ft).
  7. Install the exhaust particulate filter. Refer to Exhaust Particulate Filter Installation .
  8. Install the charge air cooler inlet hose. Refer to Charge Air Cooler Inlet Hose Replacement : 2.0L Diesel LNP .
  9. Install the engine sight shield. Refer to Engine Sight Shield Replacement .
  10. Install the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .
   


© Copyright Chevrolet. All rights reserved