To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Oil Filter Adapter and Oil Cooler Assembly Replacement

Removal Procedure
  1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
  2. Remove the turbocharger oil feed pipe from the oil filter adapter. Refer to Turbocharger Oil Feed Pipe Replacement .
  3. Remove the oil pressure switch . Refer to Engine Oil Pressure Switch Replacement .
  4. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Removal .
  5. Remove the generator. Refer to Generator Replacement : 2.4L LAF → 1.8L 2H0 → 2.0L Diesel LNP .
  6. Drain the cooling system. Refer to Cooling System Draining and Filling .
  7. Remove the oil cooler outlet hose. Refer to Engine Oil Cooler Outlet Hose Replacement : 2.0L Diesel LNP .
  8. Remove the exhaust gas recirculation valve cooling feed hose. Refer to Exhaust Gas Recirculation Valve Cooling Feed Hose Replacement .
  9. Remove the engine oil cooler. Refer to Engine Oil Cooler Replacement : 2.0L Diesel LNP → LDE, LXV, LUW, 2H0 and LFH .

    10. 2373197
  10. Remove the 4 oil filter assembly retaining bolts (3).
  11. Remove the oil filter assembly (1) along with the oil filter assembly gasket (2).

Installation Procedure
  1. Clean the sealant surfaces.

    2. 2373197
  2. Install the oil filter assembly (1) along with the NEW oil filter assembly gasket (2).

    3. Caution: Refer to Fastener Caution in the Preface section.

  3. Install 4 oil filter assembly retaining bolts (3) and tighten to 25 N·m (18 lb ft).
  4. Install the engine oil cooler. Refer to Engine Oil Cooler Replacement : 2.0L Diesel LNP → LDE, LXV, LUW, 2H0 and LFH .
  5. Install the exhaust gas recirculation valve cooling feed hose. Refer to Exhaust Gas Recirculation Valve Cooling Feed Hose Replacement .
  6. Install the oil cooler outlet hose. Refer to Engine Oil Cooler Outlet Hose Replacement : 2.0L Diesel LNP .
  7. Install the generator. Refer to Generator Replacement : 2.4L LAF → 1.8L 2H0 → 2.0L Diesel LNP .
  8. Install the drive belt tensioner. Refer to Drive Belt Tensioner Removal .
  9. Install the oil pressure switch. Refer to Engine Oil Pressure Switch Replacement .
  10. Install the turbocharger oil feed pipe to the oil filter adapter. Refer to Turbocharger Oil Feed Pipe Replacement .
  11. Fill the cooling system. Refer to Cooling System Draining and Filling .
  12. Change engine oil and oil filter. Refer to Engine Oil and Oil Filter Replacement .
  13. Install the engine sight shield. Refer to Engine Sight Shield Replacement .
   


© Copyright Chevrolet. All rights reserved