Orlando

Turbocharger Coolant Feed Pipe Replacement — 2.0L Diesel LNP

1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .

Warning: Refer to Exhaust Service Warning in the Preface section.

2. Remove the turbocharger heat shield. Refer to Turbocharger Heat Shield Replacement .
3. Remove the exhaust particulate filter. Refer to Exhaust Particulate Filter Replacement : 2.0L Diesel LNP .



4. Remove the 2 turbocharger bracket bolts (1) from the turbocharger and the engine block.
5. Remove the turbocharger bracket (2).



6. Remove the 2 banjo bolts (3) from the turbocharger and the engine block.
7. Remove the turbocharger coolant feed pipe (1).
8. Remove the 2 turbocharger coolant feed pipe gaskets (2).

1. Install the turbocharger coolant feed pipe (1) with NEW gaskets (2).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the 2 banjo bolts (3) to the turbocharger coolant feed pipe (1) and tighten to 32 N·m (24 lb ft).



3. Install the turbocharger bracket (2).
4. Install the 2 bolts (1) to the turbocharger bracket (2) and tighten to 25 N·m (18 lb ft).
5. Install the exhaust particulate filter. Refer to Exhaust Particulate Filter Replacement : 2.0L Diesel LNP .
6. Install the turbocharger heat shield. Refer to Turbocharger Heat Shield Replacement .
7. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .