To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Hydraulic Valve clearance Adjuster Replacement

Removal Procedure

  1. Remove the inlet camshaft. Refer to Inlet Camshaft Replacement .

  2. 2512542

    Note: Set aside in the order removed.

  3. Remove the 16 valve rocker arms with the hydraulic valve clearance adjusters (1).

  4. 2191139

    Note: Unclip the tappet from valve rocker arm in direction as shown (arrow). Pay attention to centring link on retaining spring (3).

  5. Remove the 16 hydraulic valve clearance adjusters (2) from the valve rocker arms (1).

Installation Procedure


    2191139

    Note: Clip in the tappet to the valve rocker arm. Pay attention to the centring link on the retaining spring (3).

  1. Install the 16 hydraulic valve clearance adjusters (2) to the valve rocker arms (1).
  2. Coat the 16 hydraulic valve clearance adjusters with engine oil.

  3. 2512542

    Note: If the valve rocker arms are being reused, the valve rocker arms must be installed in their original positions.

  4. Install the 16 valve rocker arms (1) with the hydraulic valve clearance adjusters.
  5. Install the inlet camshaft. Refer to Inlet Camshaft Replacement .
   


© Copyright Chevrolet. All rights reserved