To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Inlet Manifold Bracket Replacement

Removal Procedure

  1. Remove the starter. Refer to Starter Replacement : 2.4L LAF → 2.0L Diesel LNP with MT → 2.0L Diesel LNP with AT → 1.6L LDE, LXV, 1.8L 2H0, LUW and LFH .

  2. 2512576
  3. Remove the 2 inlet manifold bracket bolts (1) from the engine block.

  4. 2512580
  5. Remove the inlet manifold bracket bolt (2) from the inlet manifold.
  6. Remove the inlet manifold bracket (1).

Installation Procedure


    2512580
  1. Install the inlet manifold bracket (1).
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the inlet manifold bracket bolt (2) to the inlet manifold and tighten to 25 N·m (18 lb ft).

  4. 2512576
  5. Install the 2 inlet manifold bracket bolts (1) to the engine block and tighten to 25 N·m (18 lb ft).
  6. Install the starter. Refer to Starter Replacement : 2.4L LAF → 2.0L Diesel LNP with MT → 2.0L Diesel LNP with AT → 1.6L LDE, LXV, 1.8L 2H0, LUW and LFH .
   


© Copyright Chevrolet. All rights reserved