To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Valve Rocker Arm Replacement

Removal Procedure

  1. Remove the inlet camshaft. Refer to Inlet Camshaft Replacement .

  2. 2512542

    Note: Set aside in the order removed.

  3. Remove the 16 valve rocker arms with the hydraulic valve clearance adjusters (1).

  4. 2191139

    Note: Unclip the tappet from valve rocker arm in direction as shown (arrow). Pay attention to centring link on retaining spring (3).

  5. Remove the 16 valve rocker arms (1) from the hydraulic valve clearance adjusters (2).

Installation Procedure


    2191139

    Note: Clip in the valve rocker arm to the tappet. Pay attention to the centring link on the retaining spring (3).

  1. Install the 16 valve rocker arms (1) to the hydraulic valve clearance adjusters (2).
  2. Coat the 16 hydraulic valve clearance adjusters with engine oil.

  3. 2512542

    Note: If the hydraulic valve clearance adjusters are being reused, the hydraulic valve clearance adjusters must be installed in their original positions.

  4. Install the 16 valve rocker arms (1) with the hydraulic valve clearance adjusters.
  5. Install the inlet camshaft. Refer to Inlet Camshaft Replacement .
   


© Copyright Chevrolet. All rights reserved