Orlando

Exhaust Gas Recirculation Cooler Installation

1. Install the exhaust gas recirculation (EGR) cooler (1) with a NEW gasket (6).

Caution: Refer to Fastener Caution in the Preface section.

2. Install 5 retaining bolts (2, 4, 5) and the nut (3) and tighten to 25 N·m (18 lb ft).



3. Install the vacuum hose (1). Clip the vacuum hose (1) to the brackets (3).
4. Install the vacuum hose (1) to the vacuum surge tank (2) and the exhaust gas recirculation vacuum regulator solenoid valve (4).



5. Install the vacuum control solenoid valve hose (1) to the charge air bypass regulator solenoid valve and the inlet manifold runner control valve actuator.