Orlando

Window Motor Programming - Express Function

A window motor that has not been normalised will no longer perform the express up and express down functions, this may occur during the following conditions:

Note: When DTC B3205 4B & 3210 4B are set, the following warnings will be displayed on the driver information centre:

To normalise the window motor, follow these steps:

Note: The doors must be completely closed prior to normalising the windows, a door that is open or ajar may cause the power window to function abnormally or to become inoperative while performing the normalising procedure. If this occurs, verify that the door is completely closed then repeat the normalising procedure.

Note: For vehicles equipped with a folding convertible top, the top must be closed and firmly latched prior to normalizing the windows.

1. Ignition ON.
2. Starting with the window completely UP, press and hold the power window switch until the window is fully open and continue holding the switch down for approximately 5 seconds after the window is completely open.
3. Pull the power window switch up until the window is fully closed and continue holding the switch up for approximately 5 seconds after the window is completely closed.

The window should now be normalised and the window should perform the express up and express down functions.

A relearn procedure may need to be performed for any Local Interconnect Network (LIN) window motor for the following conditions:

Note: Prior to performing the relearn procedure the vehicle must have all 4 wheels properly inflated and mounted, the vehicle must be sitting on a level surface and all doors must be completely closed and for vehicles equipped with a folding convertible top, the top must be closed and firmly latched..

To relearn the window motor, follow these steps:

1. Ignition ON.
2. With a scan tool, select Module Diagnosis, Body Control Module, Configuration/Reset Functions and then select the appropriate Clear Window Learn Values for the window motor requiring the relearn procedure.
3. After the learn procedure, exit the scan tool learn procedure completely, the power window cannot be normalised and will not function until you exit the program.
4. Starting with the window completely UP, press and hold the power window switch until the window is fully open and continue holding the switch down for approximately 5 seconds after the window is completely open.
5. Pull the power window switch up until the window is fully closed and continue holding the switch up for approximately 5 seconds after the window is completely closed.

The window is now reprogrammed.