Orlando

Radiator Replacement — 2.0L Diesel LNP - AT

1. Remove the battery cover. Refer to Battery Cover Replacement .
2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .
3. Remove the charge air cooler. Refer to Charge Air Cooler Replacement : Diesel and LUJ with MT .
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
5. Drain the cooling system. Refer to Cooling System Draining and Filling .
6. Remove the radiator upper brackets. Refer to Radiator Upper Bracket Replacement .
7. Remove the radiator support bracket insulators.



8. Remove the radiator outlet hose clip (2) and the radiator outlet hose (3) from the radiator.
9. Remove the radiator inlet hose clip (5) and the radiator inlet hose (4) from the radiator (1).
10. Remove the safety rings and remove the upper and lower transmission fluid pipes (1, 6) with the transmission fluid pipe seal rings (7) from the radiator.



11. Remove the engine coolant fan shroud (1) in top direction from the 4 radiator clips (2, 3) and place it inside the vehicle.




Note: The engine coolant fan shroud (2) remains in the vehicle.

12. Hang the air conditioning condenser (3) aside and secure with safety belts.
13. Remove the radiator (1) in top direction from the vehicle.

1. Install the radiator (1) to the radiator lower support brackets.



2. Install the engine coolant fan shroud (1) to the 4 radiator clips (2, 3).



3. Install 2 NEW transmission fluid pipe seal rings (7) and clip the upper and lower transmission fluid pipes (1, 6) with the safety rings into the radiator.
4. Install the radiator inlet hose (4) with the radiator inlet hose clamp (5) to the radiator (1).
5. Install the radiator outlet hose (3) with the radiator outlet hose clamp (2) to the radiator (1).
6. Install the radiator support bracket insulators.
7. Install the radiator upper brackets. Refer to Radiator Upper Bracket Replacement .
8. Install the charge air cooler. Refer to Charge Air Cooler Replacement : Diesel and LUJ with MT .
9. Lower and unsupport the vehicle.
10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .
11. Install the battery cover. Refer to Battery Cover Replacement .
12. Fill the cooling system. Refer to Cooling System Draining and Filling .
13. Top up and correct the transmission fluid. Refer to Transmission Fluid Level and Condition Check .