Orlando

DTC P0610

This diagnostic verifies that the engine control module (ECM) is programmed for the correct vehicle options.

The ECM detects that programming for vehicle options is incorrect.

DTC P0610 00 is a Type C DTC.

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

1. Engine running, observe the DTC information with a scan tool. DTC P0610 00 should not set.
2. Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.

1. Program the K20 Engine Control Module. Refer to Control Module References
2. Clear DTCs with a scan tool.
3. Ignition OFF, allow the K20 Engine Control Module to completely power down.
4. Operate the vehicle within the conditions for running DTC P0610 00.
5. Verify with a scan tool that DTC P0610 00 has not reset.

⇒	If DTC P0610 00 does reset, replace the K20 Engine Control Module.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for ECM replacement, setup, and programming