Orlando

DTC P1255 or P064A

The engine control module (ECM) supplies voltage to the fuel pump control module when the ECM detects that the ignition is on. The voltage from the ECM to the fuel pump control module remains active for 2 seconds, unless the engine is in crank or run. While this voltage is being received, the fuel pump control module supplies a varying voltage to the fuel tank pump module in order to maintain the desired fuel rail pressure.

The engine is running.

The fuel pump control module detects an over-temperature fault.

DTCs P064A and P1255 are Type A DTCs.

DTCs P064A and P1255 are Type A DTCs.

Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records can help determine how many miles since the DTC set. The Fail Counter and Pass Counter can help determine how many ignition cycles that the diagnostic test reported a pass and/or a fail.

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Fuel System Description

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

1. Verify that DTC P0231, P0232 or P023F are not set.

⇒	If any of those codes are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .

2. Ensure that the entire undercarriage of the vehicle is clean, especially around the area where the K27 fuel pump control module is located. Clear all codes from the K27 fuel pump control module and test drive the vehicle. Verify that DTC P1255 or P064A do not set.

⇒	If DTC P1255 or P064A reset, replace the K27 fuel pump control module.

Perform the Diagnostic Repair Verification after completing the repair.

Control Module References for fuel pump control module replacement, programming and setup