To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Catalytic Converter Brace Replacement

Removal Procedure

Warning: In order to avoid being burned, do not service the exhaust system while it is still hot. Service the system when it is cool.

Warning: Always wear protective goggles and gloves when removing exhaust parts as falling rust and sharp edges from worn exhaust components could result in serious personal injury.

Caution: Refer to Exhaust Flexible Pipe Bending Caution in the Preface section.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the three way catalytic converter. Refer to Three-Way Catalytic Converter Replacement .
  3. Remove the catalytic converter. Refer to Catalytic Converter Replacement : LDE, LXV, 2H0, LUW and LFH .

  4. 2557090
  5. Remove the 2 catalytic converter brace bracket bolts (1).
  6. Remove the catalytic converter brace bracket (2).

Installation Procedure


    2557090
  1. Install the catalytic converter brace bracket (2).
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the 2 catalytic converter brace bracket bolts (1) and tighten to 58 N·m (43 lb ft).
  4. Install the three way catalytic converter. Refer to Three-Way Catalytic Converter Replacement .
  5. Install the catalytic converter. Refer to Catalytic Converter Replacement : LDE, LXV, 2H0, LUW and LFH .
  6. Lower and unsupport the vehicle.
   


© Copyright Chevrolet. All rights reserved