Orlando

Starter Replacement — 2.4L LAF

1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .



3. Disconnect the starter wiring harness plug (1).
4. Remove the starter and alternator positive cable nut (2) and the starter and alternator positive cable (3).
5. Remove the starter bolt (5) and the starter ground cable (4).



6. Remove the starter bolt (1).
7. Remove the starter (2).

1. Install the starter (2).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the starter bolt (1) and tighten to 58 N·m (43 lb ft).



3. Install the starter ground cable (4) and the starter bolt (5) and tighten to 58 N·m (43 lb ft).
4. Install the starter and generator positive cable (3) and the starter and generator positive cable nut (2) and tighten to 17 N·m (13 lb ft).
5. Connect the starter wiring harness plug (1).
6. Lower the vehicle.
7. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .