Orlando

Drive Belt Replacement

Special Tools

EN-44811 Accessory Belt Tensioner Unloader

For equivalent regional tools, refer to Special Tools .

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the engine splash shield - right side. Refer to Front Compartment Splash Shield Replacement .
3. Remove the front part of the right front wheelhousing lining. Refer to Front Wheelhouse Liner Replacement .
4. Install the EN-44811 tensioner unloader .
5. Tension the drive belt tensioner counterclockwise and hold tension.



6. Remove the drive belt (1).
7. Release tension from the drive belt tensioner and allow the tensioner to slide back slowly.

1. Apply tension to the drive belt tensioner using the EN-44811 tensioner unloader by rotating counterclockwise and hold tension.
2. Install the drive belt (1).
3. Release tension from the drive belt tensioner and allow the tensioner to slide back slowly.
4. Remove the EN-44811 tensioner unloader .
5. Inspect the drive belt for correct seat.
6. Install the front part of the right front wheelhousing lining. Refer to Front Wheelhouse Liner Replacement .
7. Install the engine splash shield - right side. Refer to Front Compartment Splash Shield Replacement .
8. Lower the vehicle.