Orlando

Engine Oil and Oil Filter Replacement

Special Tools

EN-44887 Oil Filter Spanner

For equivalent regional tools, refer to Special Tools .

1. Remove the oil filter cap (2) with the EN-44887 wrench .
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Place a drain pan under the oil drain plug.



4. Remove the oil drain plug (1) and the oil drain plug seal ring (2).

Caution: Refer to Fastener Caution in the Preface section.




1. Install the oil drain plug (1) with the NEW oil drain plug seal ring (2) and tighten to 25 N·m (18 lb ft).
2. Remove the oil drain pan.
3. Lower and unsupport the vehicle.




Note: Install a NEW oil filter (4) and a NEW oil filter cap seal (1) and (3) to the oil filter cap (2).

4. Install the oil filter cap (2) with the EN-44887 wrench and tighten to 25 N·m (18 lb ft).
5. Fill the engine with engine oil. Refer to Engine Mechanical Specifications .