Orlando

Automatic Transmission Flex Plate Replacement

Special Tools

For equivalent regional tools, refer to Special Tools .

1. Remove the automatic transmission. Refer to Transmission Replacement : 2.4L LAF → 2.0L Diesel LNP → 1.6L LDE, LXT, LXV, and 1.8L 2H0 .



2. Install the EN-43653 holding tool (1) in the starter assembly location, engaging the automatic flex plate, in order to prevent crankshaft rotation.



3. Remove and DISCARD the 6 automatic flex plate bolts (2) and the automatic flex plate (1).

Caution: Refer to Fastener Caution in the Preface section.




1. Install the 6 automatic flex plate (1) and the NEW automatic flex plate bolts (2) and tighten a first pass to 53 N·m (39 lb ft).

Caution: Refer to Torque-to-Yield Fastener Caution in the Preface section.

2. Tighten the automatic flex plate bolts a final pass to an additional 25 degrees, using the EN-45059 meter .



3. Remove the EN-43653 holding tool (1) from the starter assembly location.
4. Install the automatic transmission. Refer to Transmission Replacement : 2.4L LAF → 2.0L Diesel LNP → 1.6L LDE, LXT, LXV, and 1.8L 2H0 .