Orlando

Exhaust Pipe Front Hanger Bracket Replacement — 2.4L LAF

Special Tools

EN-45059 Angle Meter

For equivalent regional tools, refer to Special Tools .

Warning: Refer to Exhaust Service Warning in the Preface section.

Warning: Refer to Protective Goggles and Glove Warning in the Preface section.

Caution: Refer to Exhaust Flexible Pipe Bending Caution in the Preface section.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .



2. Support the catalytic converter (1) with a suitable tool.
3. Remove the 2 exhaust front pipe hanger bracket bolts (4) and the 2 drive frame bolts (3).
4. Remove the 2 exhaust front pipe hanger insulator nuts (5).
5. Remove the exhaust front pipe hanger bracket (2).

1. Install the exhaust front pipe hanger bracket (2).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the 2 exhaust front pipe hanger insulator nuts (5) and tighten the nuts to 22 N·m (16 lb ft).
3. Install the 2 drive frame bolts M10 (3) and tighten the bolts a first pass to 60 N·m (44 lb ft).

Caution: Refer to Torque-to-Yield Fastener Caution in the Preface section.

4. Tighten the bolts a final pass to an additional 30° - 45° , using the EN-45059 meter .
5. Install the 2 exhaust front pipe hanger bracket bolts M8 (4) and tighten the bolts to 22 N·m (16 lb ft).
6. Unsupport the catalytic converter (1).
7. Lower the vehicle.