Cruze

DTC B0193

The blower motor control module is an interface between the HVAC control module and the blower motor. The blower motor speed control from the HVAC control module, battery positive and ground circuits enable the blower motor control module to operate. The HVAC control module provides a pulse width modulation (PWM) signal to the blower motor control module in order to command the blower motor speed. The blower motor control module transfers the PWM signal into a corresponding blower motor voltage. The voltage resides between 2-13 V and changes linear to the height of the PWM signal.

B0193 01

The voltage at the HVAC control module output to the blower motor control module is always high.

B0193 06

The voltage at the HVAC control module output to the blower motor control module is always low or floating.

The blower motor is inoperative.

The condition for setting the DTC is no longer present.

Schematic Reference

HVAC Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Manual HVAC Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

1. Ignition OFF, disconnect the X2 harness connector at the K33 HVAC Control Module and the X1 harness connector at the K8 Blower Motor Control Module.
2. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 6 X1 at the K8 Blower Motor Control Module harness connector and ground.

⇒	If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.

3. Verify that a test lamp illuminates between the B+ circuit terminal 6 X1 and ground circuit terminal 5 X1.

⇒	If the test lamp does not illuminate, test the ground circuit for an open/high resistance.

4. Test for less than 0.3 V between the control circuit terminal 3 X1 at the K8 Blower Motor Control Module harness connector and ground.

⇒	If greater than the specified range, test the control circuit for a short to voltage.

5. Ignition OFF, test for infinite resistance between the control circuit terminal 3 X1 at the K8 Blower Motor Control Module harness connector and ground.

⇒	If less than the specified range, test the control circuit for a short to ground.

6. Test for less than 5 Ω between the K33 HVAC Control Module control circuit terminal 15 X2 and control circuit terminal 3 X1 at the K8 Blower Motor Control Module harness connector.

⇒	If greater than the specified value, test the control circuit for an open/high resistance.

7. If all circuits test normal, replace the K8 Blower Motor Control Module and verify the DTC does not reset.

⇒	If the DTC resets, replace the K33 HVAC Control Module.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.