Preliminary Procedure

Remove the tyre and wheel assembly. Refer to Tyre and Wheel Removal and Installation .

1

Steering Linkage Track Rod Nut

Caution: Refer to Fastener Caution in the Preface section.

Tighten
35 N·m (26 lb ft)

2

Steering Linkage Inner Track rod Nut

Tighten
60 N·m (44 lb ft)

3

Steering Linkage Outer Track rod

Procedure

1. Use CH-161-B puller to separate the steering linkage outer track rod from the steering knuckle.
2. Inspect the steering linkage inner track rod for bent or damaged threads.
3. Clean the tapered surface of the steering knuckle.
4. Check and adjust wheel alignment. Refer to Wheel Alignment Measurement .
5. Centre the steering angle sensor. Refer to Steering Angle Sensor Centreing .

Special Tools

CH-161-B Puller

For equivalent regional tools, refer to Special Tools .